Used on docks where excessive friction from up and down trailer
movement occurs (yard jockeys air ride trailers etc.).
Can be used in material handling application where medium to heavy dock
protection is required
“Gliding” heavy-duty steel face is 3/8” thick and independently anchored with elongated holes to face of bumper allowing bumper to compress AND offer high surface abrasion resistance
Rubber pads laminated between steel angles and secured with 3/4” rods
Bumper is fastened to dock surface with 3/8” steel angles and/or flat plates depending on the model chosen.
Compatible with various LiftMaster® DC Swing and Slide Gate Operators; manufactured after 2016.
This board is backwards compatible for older second generation units but will require UL325 Entrapment Protection System and Photoelectric Sensors or Edge Sensors.
Standard transmitter included with all GTO gate operators
Much smaller in size than previous model and improved signal range
The single button controls the gate operator and has adjustable code settings and has (new miniature) visor clip for your vehicle and now a whole for key-ring or key chain.
It is compatible with GTO and Mighty Mule gate operators
The code settings are the 9 dipswitches located inside the cover.
MGJ is designed for use on rolling grilles and shutters.
Maximum recommended duty cycle: 12 cycles per hour.
Heavy-duty wormgear-in-oil-bath speed reducer
3-button station for open/close/stop functionality
315 MHz radio receiver is integral to the Medium-Duty Logic board
UL325-2010 Monitored Entrapment Capability (provides primary monitored entrapment protection through monitored photo sensors: either CPS-U or CPS-UN4 or a 4-wire monitored edge using the CPS-EI interface)
390 or 315 MHz rolling code compatible 3-Button 3-Channel remote transmitter
Works with Genie and Overhead Door openers that utilize a ROLLING CODE 315 or 390 MHz
Compatible with Genie model GIC-3 GIT90-3 GIT-3 GIT-3BL G2T-3 G2T-3BL GICT390-3BL ACSGT ACSCTG Type 1 ACSGT Type 1 TBSTG Type 1 Series II Electronics Compatible Remote and B8QACSC
Doors used with this operator should be balanced with the ability to be manually lifted by hand in an emergency or power outage.
The operators are typically mounted to the wall when used with smaller sectional overhead doors with a vertical or high lift and mounted to the wall or the front of the hood when used with rolling doors and grilles.
J operators are attached to the door jackshaft to indirectly drive the door
MyQ® Technology enables you to securely monitor and control your facility operator and lights with your smartphone tablet or computer for greater peace of mind.
Security+ 2.0® safeguards your facility – with every click a new code is sent to the commercial door operator so the door opens only for you
Manufactured to the highest quality standards to ensure accurate detection our Pre-formed loops come with a 50 foot twisted lead-in ware and available lead-in lengths up to 500 feet.
Ideal for use on existing asphalt or concrete surfaces
Features a non spliced continuous wire throughout loop turns and lead-in.
requires the use of loop sealer when being installed to ensure long lasting trouble-free detection